Lesson 9: Switches, Fuses and Relays
How switches, fuses and relays work: normally open and closed switches, why fuses protect wiring, and a working 4-pin car relay with pins 30, 85, 86 and 87.
Builds on Lesson 8: How to Use a Digital Multimeter
In this lesson you’ll learn
- How switches control a circuit
- Normally open versus normally closed
- What a fuse does and why it protects wiring
- Choosing the right fuse rating
- How a relay works
- Pins 30, 85, 86 and 87 on a four-pin relay
Lesson summary
- A switch opens or closes a circuit. It is wired in series with the load it controls.
- Normally open (NO) contacts close when operated; normally closed (NC) contacts open when operated.
- A fuse is a deliberate weak link: it melts and opens the circuit when the current is too high, protecting the wiring from overheating.
- A fuse must be rated to protect the wire it feeds. Never fit a bigger fuse, and never bypass one.
- A relay uses a small control current through its coil to switch a large load current through its contacts.
- Four-pin relay: 85 and 86 are the coil (control circuit); 30 and 87 are the contacts (load circuit).
Lesson notes: Switches, Fuses and Relays
A written version of this lesson. The hands-on simulators are in the lesson itself.
Switches: open and closed
A switch makes or breaks the path for current. Some stay where you put them; others only change while pressed.
Try each type. Press and hold the push buttons (in the diagram, or with the button).
Key idea: Normally open (NO): off until operated. Normally closed (NC): on until operated. “Normally” means the resting state.
Fuses protect the wiring
Too much current makes a wire hot: enough to melt its insulation and start a fire. A fuse is a thin link, in series, that melts first and opens the circuit.
Create a short circuit and watch the fuse. Then remove the short and replace the fuse.
Key idea: A fuse protects the wiring, not the device. It must be rated at or below what the wire can safely carry. (In this model a fuse blows the instant its rating is exceeded; real fuses take longer on a small overload.)
Relays: a small current switches a big one
A cooling fan can draw 10 A or more. Running that through a dashboard switch would need thick wiring and a heavy switch. Instead, a relay does the heavy switching.
- Control circuit: a small current flows through the relay’s coil (pins 86 and 85). The coil becomes an electromagnet.
- Load circuit: the magnet pulls the contacts together, connecting pin 30 to pin 87 and powering the load.
Turn the switch on and compare the two currents.
Key idea: The two circuits are separate. The coil is only an electromagnet; the load current never flows through the switch. (A typical 12 V relay coil is about 80 Ω, so it draws 0.15 A.)
Worked examples
A 12 V relay coil has a resistance of 80 Ω. What control current does the switch carry?
I = V ÷ RI = 12 V ÷ 80 ΩI = 0.15 A, tiny compared with the 10 A fan current
No experience needed. Answer as you go; you can always try again.