Automotive ElectricalLesson 12: How to Read Electrical Wiring Diagrams
Module 9: Wiring Diagrams

Lesson 12: How to Read Electrical Wiring Diagrams

How to read wiring diagrams: common electrical symbols, wire colour codes, connectors and grounds, and tracing a car horn circuit from power to ground.

  • About 30 minutes
  • 5 questions
  • 1 hands-on activity

Builds on Lesson 11: Introduction to Automotive Electrical Systems

In this lesson you’ll learn

  • What a wiring diagram represents
  • Common symbols: batteries, fuses, switches, relays, lamps, motors
  • Grounds and connectors
  • Wire colour codes and identification
  • Tracing a circuit from power to ground
  • Finding where a broken circuit stops
Lesson summary
  • A wiring diagram shows electrical connections, not where parts physically sit in the vehicle.
  • Symbols are standard: learn the battery, fuse, switch, relay, lamp, motor, connector and ground.
  • Wire codes give colour (e.g. RD/WH = red with a white stripe) and often size in mm².
  • Trace every circuit the same way: from the power source, through fuses, switches and relays, to the load, then to ground.
  • Wire colours can change at connectors. Follow the actual path, not the colour alone.
  • A circuit stops where test readings change from supply voltage to 0 V (or where both sides of a load read the same).

Lesson notes: How to Read Electrical Wiring Diagrams

A written version of this lesson. The hands-on simulators are in the lesson itself.

A map of the electrical connections

A wiring diagram shows how components are connected electrically: which wire goes where, through which fuse, switch and connector.

It is not a picture of the car. A fuse drawn next to a horn might be a metre away in reality. The diagram is about the path, not the position.

Most manufacturers draw power at the top of the page and ground at the bottom, so current flows down the page.

Key idea: Read a diagram like a route map: start at the power source and follow the path to ground.

Common symbols

These are the symbols used throughout this course, and on most automotive diagrams.

Key idea: Symbols vary slightly between standards and manufacturers (for example, a resistor is a rectangle in IEC drawings and a zig-zag in US ones). Every manual includes a symbol key: check it.

Identify the parts of a horn circuit

This is a simplified horn circuit, drawn the way a workshop manual would. Click components to identify them.

Wire labels like RD/WH 1.5 mean a red wire with a white stripe, 1.5 mm² in size. GN is green, YE yellow, BU blue, BK black.

Key idea: Every component has a reference (F12, K3, C201, G101) that matches the vehicle’s fuse box labels, location charts and connector views.

Trace the path from power to ground

Click the parts in the order current flows through them, starting at the battery. Trace the load circuit first, then the control circuit.

When a path is complete, hold the horn switch to see it work.

Key idea: Power → protection (fuse) → control (switch or relay) → load → ground. Trace both the load path and the control path of a relay circuit.

Find where the circuit stops

A wiring diagram tells you where to test. Someone holds the horn switch while you check for voltage at each test point.

Find the point where 12 V becomes 0 V, then click the wire, connector or ground that’s broken.

Key idea: Voltage on one side of a part and none on the other means the break is between them. Voltage on both sides of a load means its ground side is open.

No experience needed. Answer as you go; you can always try again.